jtag voor simba waar ??

[PinkFlamingo]

wie weet waar ik een jtag voor een aston simba kan bestellen ? ik heb al gezocht maar kan nergens iets vinden ... wie helpt ?

[Gast]

Hey satm8,

 

Zelf maken!!!

Je vind info genoeg van J-tag op Patel-basis..

 

Groeten,Patsat <img src="/ubbthreads/images/graemlins/xyxthumbs.gif" alt="" />

[PinkFlamingo]

ik weet het ... maar ik ben niet zo'n kunstenaar met de soldeerbout (of juist wel natuurlijk <img src="/ubbthreads/images/graemlins/grin.gif" alt="" /> <img src="/ubbthreads/images/graemlins/grin.gif" alt="" /> <img src="/ubbthreads/images/graemlins/grin.gif" alt="" />) plus dat ik dan nog moet weten hoe ik het precies moet doen ...software etc <img src="/ubbthreads/images/graemlins/kweetniet.gif" alt="" /> maar als je me per PM verder kunt helpen was dat niet gek ... <img src="/ubbthreads/images/graemlins/xyxthumbs.gif" alt="" /> ik leer nog graag iets bij weet je ...

 

groetjes ...

[Gast]

Hoi,

Zal een beetje helpen.

lees dit maar eens door allemaal en dan mailen voor files.

Some Instructions for using WIGGLER JTAG with Aston Simba.

==========================================================

 

THESE ARE THE BASICS THAT SHOULD GET YOU GOING.

 

Start the GSP program

 

A Box called 'OCD FLASH Registration' pops up. Enter 1 for the Registration Code and click on OK.

 

From the FILE menu choose OPEN and select the file that matches the flash chip on your simba (Simba AMD Flash.ocd, Simba SHARP Flash.ocd or Simba TOSHIBA Flash.ocd - the toshiba file is definitely ok as I use it myself, the other two should be okay).

 

TO DUMP THE CONTENTS OF SIMBA FLASH TO FILE (BOOT AND APPLI):

Click on RESET TARGET, a box should pop up saying TARGET RESET ASSERTED click on OK in that box.

Click on UPLOAD FLASH, after a delay of a few seconds a box will open called 'Upload Flash to .s19 File'. Enter a file name next to UPLOAD FLASH TO: then click on UPLOAD.

It will take around fifteen minutes to complete, when it has click on CLOSE to return to the main options.

 

TO REPROGRAM THE SIMBA FLASH FROM FILE (BOOT OR BOOT & APPLI):

Click on RESET TARGET, a box should pop up saying TARGET RESET ASSERTED click on OK in that box.

Click on PROGRAM, after a delay of a few secons a box will open called 'Program Flash'.

Enter a filename next to READ PROGRAM FROM: (Use the BROWSE button if you need to). Make sure the check box is ticked next to ERASE TARGET FLASH SECTOR(S) BEFORE PROGRAMMING.

Click on PROGRAM. You should see it erase the necessary sectors and then proceed to program them. The boot on it's own takes about five minutes, the boot & appli will take around fifteen minutes to complete.

When it has finished click on CLOSE to return to the main options.

If you flashed ONLY THE BOOT then you may have to reflash the appli using the LOADER.EXE program through the RJ45 port.

 

GOOD LUCK!

 

Patsat <img src="/ubbthreads/images/graemlins/xyxthumbs.gif" alt="" />

[PinkFlamingo]

ik heb de onderdelen binnen zal zien dat ik hem morgen inelkaar heb zitten